AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Instaling mpv 0.361/28/2024 SAE J945 requires an average of at least three consecutive cycles. For the emergency distress signal mode, the flash rate will be 71 FPM for a normally open type flashes with an average current ON time of 65%. For the hazard signal mode the flash rate will be 70 FPM for a normally closed type flashes and the current ON time is 59%. 108 that would require a distress signaling system on vehicles.īased on the times stated in the "Product Specification for the Code II," the flash rates and the percent of current "ON" time will meet the requirements of SAE J945 and FMVSS 108 for both modes. I am enclosing a copy of 49 CFR Part 552, setting forth the procedures under which you may petition for an amendment of Standard No. If your device meets all other requirements of SAE J945 and SAE J910, the standard for hazard warning signal operating units also incorporated by reference, it should comply with Standard No. You also asked as to the steps necessary to make it mandatory.įrom the specifications provided in your letter, it appears that both modes of operation (hazard and distress) would comply with the flash rates and the percent of current "on" time required by SAE J945, the standard for hazard warning signal flashers incorporated by reference in Standard No. TEXT: This is in reply to your letter of Augasking whether your emergency hazard signaling system conforms with Federal Motor Vehicle Safety Standard No.
0 Comments
Read More
Leave a Reply. |